|
Installing the C-12:
Remove the three set screws from the clamp with the 2.5mm hex key. | Thread the Brass Bushing into the clamp's central hole (thread it in from the bottom surface of the clamp using a penny or similar sized coin as an installation tool). Make sure the bushing is fully threaded-in and not sticking up proud. The purpose of the bushing is to keep the bubble level from falling out of the stem of the head. | Replace the removed set screws with the three enclosed M3 screws by placing them into the holes on the front of the clamp. Note: There should be a piece of foam in the stem’s central hole; do not remove it. Its purpose is to keep the stem’s bubble level from rattling around. | Set the clamp on the stem, matching up the three holes on the stem with the three screws. Attach the Clamp to the ball head using the 2.5mm hex key. |
C-12 Installed:
© Copyright 2020 - Wimberley, Inc. - All Rights Reserved
Made in USA and Assembled in Charlottesville, VA |